How to Install Vinyl Plank Flooring on a Concrete Garage Floor?
There are many different methods of installing vinyl plank flooring on a concrete garage. Whether you choose a click-lock, glued-down, or peel-and-stick method, there are a few steps you should follow. Here are some basic steps:
(Get those outdated old countertops completely updated to breathe new life into your home or business! Contact us today. Click here: Renew Resurfacing)
Click-lock
The first step to installing vinyl plank flooring on a concrete garage is preparing the subfloor. It should be completely dry before attempting to install the planks. You can also use a leveling compound to fill in low spots. Make sure you follow the manufacturer’s instructions when preparing this compound. After the concrete subfloor is completely dry, you can start installing the vinyl planks. To get started, measure the room, and then make a plan to lay out the flooring. Having a plan will also make the installation process easier.
You should mark out the first row of planks. Remember that the first row must be smaller than the second. Make sure to leave a gap of about 1/4 inch between the first row and the second row. This will prevent the floor from buckling if there isn’t enough expansion space. To ensure even spacing, use a chalk line to mark the first row. Then, start the installation from the center point. Apply the adhesive in a circular motion, working your way outwards.
Glue-down
The first step in gluing down vinyl plank flooring is to create a hole in the concrete garage floor. Before gluing down the floor, you should check that the hole is large enough to accommodate the entire length of the planks. Then, roll the sheet vinyl into the adhesive, making sure to roll it into a radius of at least one inch. This step is critical because if the floor is too narrow or too wide, the glue could seep in between the planks, resulting in a leaky surface. Once the floor is dry, you can glue down the other half of the sheet.
Before gluing down vinyl plank flooring, you should first ensure that the concrete garage floor is clean and dry. If the concrete garage floor is damp, you should make sure that it is completely dry. Glue-down flooring can be tricky to install, so make sure that it is properly prepared. You can start by measuring the area where you will lay the flooring. After that, cut a circle out of the center of the hole. Then, use a pencil or other sharp object to make the hole bigger.
Peel-and-stick
Preparing the subfloor is a vital part of installing any flooring. You should decide on the type of flooring you’ll install before you begin. After you’ve determined which type of flooring you’ll use, you’ll need to plan the layout of the planks. Planning will help the process go faster. To make the installation process easier, it helps to know the dimensions of the room in which you plan to install the flooring.
Start by measuring the width of the room. Decide on several planks for each row. You need to leave a gap of about 1/4 inch between each row. You may need to cut the first row a bit to fit the space. Remember, that the first row will be narrower than the others. If necessary, you can trim the first row so that it’s the same size as the last.